Home › Forums › Open Discussion › missing Orca card and office card-key
- This topic is empty.
-
AuthorPosts
-
May 9, 2013 at 2:42 am #607444
JKBParticipantAnybody pick up a couple of stray cards off the bus? Had them for my ride home on the 56/57 Friday night. Monday morning I couldn’t find them, even though they have to be someplace obvious.
It’s a blue Orca card and a plain white office cardkey, nothing printed on it but there’s some writing in black Sharpie.
Arrgh, I know they’ll turn up just right after I give up looking and get them replaced.
May 9, 2013 at 3:10 am #789727
miwsParticipantJKB, have you contacted Metro’s Lost & Found, in case the driver found the cards, (or a passenger found them and turned them in to the driver)?
http://metro.kingcounty.gov/cs/lostnfound.html
Just a note though, I got an e-mail from Metro earlier today, stating that due to construction near their office, the Customer Service number; 206-553-3000, could be disrupted overnight until 6:00 am tomorrow.
Also, did you register your ORCA Card? If so, you can put a freeze on its use, and if you end up getting a replacement card, they can transfer the balance from the old one to the new one.
https://www.orcacard.com/ERG-Seattle/p2_002.do?m=42&i=418
Mike
May 9, 2013 at 3:56 am #789728
JKBParticipantYes, and no. Called lost+found, they put me on hold for ten minutes, then said no such cards had turned up. So either they hadn’t, or that’s how long it takes to go out for a smoke.
And I hadn’t registered the Orca. Didn’t know about registering. And while it’s in the fine print, they sure don’t make it clear. Anyway, without registering it they won’t do a thing.
Does 553-3000 ring at the 2d&Jackson office? The street there is certainly under a lot of construction. That’s actually where I went to inquire – I was standing in their lobby calling the number.
May 9, 2013 at 4:34 am #789729
miwsParticipantI don’t know for sure if 553-3000 rings in to that office, but presume it does, since that’s their Main Office.
Mike
-
AuthorPosts
- You must be logged in to reply to this topic.