Last February, we reported on the “burnout backlog” – thousands of Seattle City Light streetlights awaiting repair. In February, there was word of a plan to speed it up by moving up some spending. Now, a progress report – read on:Read More

When WSB broke the story July 13 about hundreds of leaks in the waterproofing “membranes” atop the new concrete covers at Myrtle Reservoir in West Seattle and Beacon Hill Reservoir, Seattle Public Utilities told us they had not yet calculated the cost of redoing those membranes. They stressed that they expect the cost eventually will be someone else’s responsibility – depending on where the fault is found to lie – but in the meantime, the city has to front the money to get the work redone. The faulty membranes are being removed now, and a “hot asphalt” process will be used instead. SPU’s Andy Ryan has just sent us the information on the costs, as he had promised they would do as soon as “change orders” were complete:

We now have an estimate on the cost of removing and replacing the waterproof membranes at the Beacon and Myrtle reservoirs — about $4.1 million.

As you reported last week, once liability for the waterproofing problem has been established, Seattle Public Utilities will be seeking recovery of costs from our vendors.

We have not yet established the cause of the breaches in the waterproofing material, nor have we fixed responsibility for the problem. As we told you last week, that determination will likely be part of a lengthy legal discussion between SPU, the project designer and the contractor. To reiterate what we said last week, we do not believe SPU is responsible for any of these problems.

Overall, Seattle’s $150 million reservoir covering program is about $15 million under budget.

Please allow us to emphasize, again, that the water in the reservoirs is safe. We have a comprehensive water quality testing program, regulated by Washington State Department of Health, that confirms that there are no water quality impacts from the waterproofing problem. In fact, at Beacon and Myrtle the water is much better protected, and the water quality even higher, than in Seattle’s old, uncovered reservoirs. The state Department of Health is fully informed of these issues and believes our water is safe.

Construction work on the Beacon and Myrtle Reservoirs is expected to be completed by the end of November. Until the work is completed, the two reservoirs will remain fenced off, as has been the case with our open reservoirs.

Our first priority is getting the waterproofing done right on these projects, which will be serving Seattleites — as reservoirs and parks — for at least the next 100 years.

Our original story on the waterproofing leaks stemmed from neighbors’ e-mails to WSB, asking why the project – which they had thought to be complete – “was being dug up again.” (We also published a followup later in the week.) Earlier this week, we asked SPU why we hadn’t seen activity at the site for several days; Ryan and reservoir project manager Stephanie Murphy explained that the crews are removing the membrane material at Beacon right now and scheduled to resume work at Myrtle in early August.

When we broke the story on Monday night of hundreds of leaks requiring the waterproofing membranes to be dug up, removed and reinstalled at Myrtle Reservoir in West Seattle and Beacon Hill Reservoir, our story was cited and linked to by more than half a dozen citywide media sources, including SeattleTimes.com (almost 4,000 people clicked from there to come see the story here). Now today, three days later, the Times has done its own followup, also appearing in the print edition – which (thank you!) again credits WSB for breaking the story – read the new Times story here. The reporter, Susan Kelleher, is the same one who just last weekend broke the story of SDOT do-overs (including ramps along Fauntleroy Way) – she also was unable, however, as were we, to pin anybody down on specifics of cost/blame re: the reservoir membranes – but SPU has promised some cost information next week, so we’ll bring that to you as soon as it’s available. Meantime, we had asked SPU’s Andy Ryan some other followup questions — read on for the answers:Read More

No surprise that an electric utility would get some trucks that run partly on … electricity. Seattle City Light just unveiled two new hybrid diesel-electric trucks that are going into service starting today, and provided the photo you see above — read on for the official news release, which says they’re quieter, too:Read More

Amy e-mailed to ask what we’d heard about a power outage on Gatewood Hill. Nothing — till her note. Checked with Seattle City Light; the boundaries (seldom precise) are listed as Fauntleroy Way north, SW Orchard south, 37th SW east, Parshall Place west. It’s affecting about 80 homes. No word on the cause; they’re estimating it’ll be fixed by 1:30 am.

(Thursday night photo by Christopher Boffoli)
As you probably know by now, even if you weren’t affected, 3,000 West Seattle homes and businesses were without power for up to five hours last night – mostly in north and northeast West Seattle. Here’s our as-it-happened coverage from last night; this morning, we checked with Seattle City Light‘s Scott Thomsen to see if a specific cause (aside from “weather”) had been nailed down, and here’s his reply:

We believe it was caused by a tree crossing two phases of a feeder, which creates a short circuit and throws the breakers. Our crews followed the full length of the line looking for damage. As they cleared each section, they brought it back to service. They did not find any damaged equipment.

(Wondering “what’s a feeder”? Thomsen’s explanation: “Feeder lines take electricity from substations into neighborhoods. They typically carry enough electricity for 3,000 to 4,000 homes and businesses.”) Again, everything’s back to normal today, including the Admiral Theater, which starts Seattle International Film Festival showings this afternoon – and is site of the free fun West Seattle SIFF celebration to which you’re invited, Seafair Pirates and treats and more, 5:30-6:45 tonight, hope to see you there!

We recently got a note from Jeff wondering about progress on the Alki pump station project, which has now been under construction for almost a year and a half. So we checked with the King County Wastewater Treatment Division folks, and Heidi Sowell sent an update – note the chance to ask your questions in person during Sunday’s “Celebrate Seattle Summer Streets” event (closing Alki to most traffic 9 am-5 pm that day). Here’s what Heidi sent:

Crews are completing the construction of the pump station. Much of the current work on the project is occurring below ground and improvements may not be as noticeable to those living, working and visiting the area.

… 53rd Avenue Pump Station Upgrade
In February 2008, construction began on upgrades to King County’s 53rd Avenue Pump Station in West Seattle. This underground wastewater facility, located on the west side of Alki Avenue Southwest at 53rd Avenue Southwest, is more than 50 years old and in need of repairs, new equipment and more underground space.

The 53rd Avenue Pump Station will remain underground but will be about three times as large. Current improvements to the Pump Station will bring the facility into compliance with current code and design requirements while also increasing reliability. The pump station will help manage combined stormwater and wastewater flows from nearby neighborhoods and will reduce overflows into Puget Sound.

Construction Milestones

* Utility and storm drain relocation – Spring 2008
* Force main installation – July 2008
* Sheet pile driving – August 2008
* Pump station excavation – Fall 2008
* Pump station construction – Winter 2008 through Summer 2009
* Testing of upgraded facility and property restoration – Fall 2009

Learn more at http://dnr.metrokc.gov/wtd/projects/westseattle/53rdAvePS/ or visit us
at the Alki Seattle Summer Streets event this Sunday from 9 am – 2 pm (near the pump
station). Thank you for your continued patience through the 53rd Avenue Pump Station
construction!

Thanks to the tipster who called us about this; last night, after a “transformer fire” call nearby, we heard from one person who was without power for a while, but they got it back by 9:15 pm and we heard no further reports. However, this morning Starbucks is closed (expecting to open 10-ish, per a note on the door), the QFC is open under generator power, and some other businesses are closed. Checking with City Light to see what’s going on. Checking at WV, it only appears to be the building with QFC etc. – Target and McDonald’s are unaffected. 9:29 AM UPDATE: Peter Clarke from City Light tells WSB the power should be back any time now, adding:

The problem was a transformer outage. The crew worked through the night to replace the transformer which originally was reported out at 7:38 p.m. The boundaries of the initial outage were on the north: SW Trenton St; on the south SW Barton St; on the east 25 Ave SW and on the west 27 Ave SW. Initially City Light estimates there were 133 customers without power, however, 80 % were restored power by 9 p.m.

We reported earlier this year on the big backlog at Seattle City Light – report a burned-out street light, wait weeks, maybe months, for it to get fixed. The mayor says he’ll take that on – news release ahead:Read More

The first area news story to break as West Seattle Community Garage Sale Day was winding down on Saturday afternoon happened to be a power outage on Harbor Island (original WSB story here). It left us with two followup questions, both of which have just been answered by Seattle City Light: First, a WSB’er asked, how could a Harbor Island outage involve 552 “customers” (since that means individual entities, not people)? SCL’s Mike Eagan explains the outage stretched along East Marginal Way a ways, too. Second, we wondered how just one seagull could cause that kind of trouble by landing on a “transmission line,” and before we could even make a call this morning to ask that, SCL’s Scott Thomsen read our comment and e-mailed:

A bird crashing into a power line would be unlikely to damage the line by the force of the impact. Birds cause outages by creating a new circuit when they touch two different lines. When such a short circuit occurs, it’s the electricity that does the damage by overloading the system. The bird is the connection that allows it to happen. When a bird lands on a single line and doesn’t touch anything else, they’re fine. You see this every day. The reason is that the bird is not creating a new, shorter circuit for the energy. The bird has a higher level of resistance to the electricity than the wire does, so the electricity takes the path of least resistance through the wire.

By the way, City Light’s outage page – including what to do if one happens, who to call, etc. – is here.

Other news is starting to break, just as West Seattle Community Garage Sale Day wraps up. Just got word from Seattle City Light that more than 500 customers on Harbor Island are without power, because of a seagull hitting a power line. Here’s the official news release from City Light’s Mike Eagan:

About 552 City Light customers on Harbor Island and along Alaska Way South lost power about 1:15 p.m. today. Most are expected to have power restored by 4 p.m.; the remainder within another three hours.

The outage was caused by a seagull hitting a transmission line. A City Light crew has been called in from home to replace a section of the line.

The Todd Shipyard was among those who lost power, as well as portions of Stevedoring Services of America.

7:20 PM UPDATE: According to the most recent update from City Light, e-mailed just under an hour ago, everyone has their power back except the site where the gull-vs.-line actually happened, the Burlington Northern Railroad yard; about that, Eagan writes, “A City Light repair crew was called in from home to replace the section of line and City Light expects power to be restored to Burlington Northern by 8:00 p.m.”

Lots of discussion here following the city’s update on the recycling/trash transition Thursday, now there’s a sequel: The city is cracking down on the apartment/condo pickup problems – read on:Read More

Seattle Public Utilities says its first week and a half of recycling, yard/food waste, and trash pickup changes has gone relatively smoothly, with a half-percent miss rate for home customers and five percent for apartment/condo/commercial customers. It’s expanded the call-center hours so that if you’re missed or have some other problem, you can reach someone at 684-3000 7:30 am-7 pm weekdays, 9 am-1 pm Saturdays. SPU also says it has “inspectors” trailing crews to check for trouble. (Photo by Christopher Boffoli)